Bosch Factory Service ManualFault Code: E02

Bosch Refrigerator Error Code E02: Freezer Evaporator Temperature Sensor Defect

The NTC thermistor sensor clipped to the freezer evaporator coil is reporting an open circuit, short circuit, or erratic reading outside normal range.

OEM Brand: BoschAppliance: refrigeratorVerified OEM Diagnostics
Bosch refrigerator diagnostic bench testing and technical inspection for error code E02
Bosch REFRIGERATOR Diagnostic BenchCODE: E02
Target Appliance

refrigerator

OEM Certified Technical Diagnostic Tree

Diagnostic Tool Required

Digital Multimeter

Measure Ohms resistance, continuity & line voltage.

Triage Complexity

Advanced Diagnostic

4 Sequential manufacturer inspection branches.

Sequential Factory Diagnostic Tree

Perform each diagnostic step in order. Disconnect electrical power and turn off utility shutoffs before inspecting wiring or internal mechanical assemblies.

Digital multimeter measuring ohms resistance and terminal pin continuity on appliance electronic control board
Bench Testing Protocol

Multimeter Resistance & Continuity Verification

Before replacing any electronic control board or mechanical sensor, disconnect power and measure terminal resistance using a calibrated digital multimeter. Verify continuity (0 ฮฉ) across safety switches and compare sensor resistance against OEM specs in the diagnostic steps below.

Step 1: Physical & Electrical InspectionMultimeter & Visual
Action: Disconnect power, remove freezer rear interior back panel to access the evaporator coil and NTC thermistor.
Bench Test: Inspect NTC sensor casing for cracked plastic, moisture ingress, or frost heave damage.
Expected Standard: Sensor probe sealed, clipped firmly to suction line or upper coil return bend.
If Failed / Out of Spec:

Replace evaporator NTC temperature sensor (00623143).

If Passed:

Proceed to Step 2.

Step 2: Physical & Electrical InspectionMultimeter & Visual
Action: Measure sensor resistance in an ice water bath (32ยฐF / 0ยฐC).
Bench Test: Submerge sensor tip in ice bath and measure resistance across sensor wire leads.
Expected Standard: 16,300 ohms (16.3k ฮฉ) at 32ยฐF; approximately 5k ฮฉ at room temperature (77ยฐF).
If Failed / Out of Spec:

Resistance out of tolerance (0L or 0 ohms). Replace sensor (00623143).

If Passed:

Proceed to Step 3.

Step 3: Physical & Electrical InspectionMultimeter & Visual
Action: Test wiring harness continuity from freezer interior connector to main control PCB in rear machine compartment.
Bench Test: Check continuity across sensor harness pins.
Expected Standard: 0 ohms continuity; clean pins with zero corrosion.
If Failed / Out of Spec:

Repair harness wiring or replace molex connector.

If Passed:

Proceed to Step 4.

Step 4: Physical & Electrical InspectionMultimeter & Visual
Action: Inspect main electronic control PCB in rear compressor compartment.
Bench Test: Check sensor input DC circuit traces for burned components or cold solder joints.
Expected Standard: 5V DC reference voltage delivered across sensor terminals from PCB.
If Failed / Out of Spec:

Replace main electronic control board (11020478).

If Passed:

Run diagnostic self-test to clear fault history.

Verified OEM Replacement Parts

Cross-referenced factory part numbers for Bosch refrigerator error code E02. Always replace defective components with authentic OEM parts to maintain UL safety certification.

Component NameOEM Part NumberManufacturerStatus
Freezer Evaporator NTC Thermistor Sensor00623143BoschDirect Fit OEM
Main Electronic Power Control Board11020478BoschDirect Fit OEM
Defrost Heater & Bimetal Thermostat Assembly00649363BoschDirect Fit OEM

Estimated Repair Cost Ranges: Bosch E02

Repair costs for Bosch refrigerators displaying error code E02 vary based on component damage, accessibility, and whether you self-install or dispatch a local factory-trained technician.

DIY Replacement Part

$140 โ€“ $340

Direct OEM replacement part cost (excluding tools, shipping, or diagnostic meter equipment).

Pro Diagnostic Fee

$89 โ€“ $149

Standard in-home diagnostic evaluation fee by an independent technician (typically applied toward repair).

Total Pro Repair Range

$320 โ€“ $590

Typical total job cost including in-home diagnostic, authentic OEM parts, and professional labor (60โ€“120 mins).

Pricing & Diagnostic Disclosure:

The pricing figures provided above represent broad industry averages based on nationwide market surveys and component replacement requirements. Pricing depends on multiple factors including the specific appliance brand, age, mechanical condition, diagnostic complexity, accessibility, and local labor rates. All independent repair contractors set their own independent rates and fee structures. An in-home diagnostic evaluation by an authorized technician is required to provide an exact written quote prior to any repair work.

Related Symptom Triage Guides for Bosch refrigerators

If your appliance displays code E02 alongside physical operational symptoms, consult our dedicated failure triage flowcharts:

Symptom Triage

Why Is My Ice Maker Clicking but Not Dumping Ice? Diagnostics

View Triage Flowchart โ†’
Symptom Triage

Why Is My Ice Maker Not Making Ice? Troubleshooting Guide

View Triage Flowchart โ†’
Symptom Triage

Why Is My Refrigerator Freezing Food in the Fresh Food Section?

View Triage Flowchart โ†’
Symptom Triage

Why Is My Refrigerator Leaking Water? Diagnostic Guide & Causes

View Triage Flowchart โ†’
Engineering Service Hub

Looking for Full Refrigerator Repair Procedures?

Explore comprehensive diagnostic mechanics, component resistance curves, and EPA guidelines for Bosch units.

Refrigerator Repair Specs โ†’
Local In-Home Diagnostic Dispatch

Tired of Troubleshooting Code E02? Get a Local Bosch Technician.

If multimeter bench tests confirm component failure or you prefer a professional to safely service your high-voltage Bosch refrigerator, connect with an independent certified specialist in Colorado, Kansas, or New Mexico today.

(945) 206-7476 Urgent: (855) 796-2411Mon-Sun 7amโ€“9pm โ€ข Fast Local Dispatch
Local In-Home Service DispatchSame-Day Available

Need In-Home Diagnostic Dispatch for Code E02?

If multimeter testing confirms an internal short, failed heating element, locked motor, or burnt control board on your Bosch refrigerator, connect with an independent certified technician in your city.

refrigerator repair in Olathe, KS
Olathe, KS Dispatch Hub
โ†’
refrigerator repair in Overland Park, KS
Overland Park, KS Dispatch Hub
โ†’
refrigerator repair in Wichita, KS
Wichita, KS Dispatch Hub
โ†’
refrigerator repair in Lawrence, KS
Lawrence, KS Dispatch Hub
โ†’
refrigerator repair in Topeka, KS
Topeka, KS Dispatch Hub
โ†’
refrigerator repair in Kansas City, KS
Kansas City, KS Dispatch Hub
โ†’
refrigerator repair in Denver, CO
Denver, CO Dispatch Hub
โ†’
refrigerator repair in Colorado Springs, CO
Colorado Springs, CO Dispatch Hub
โ†’
refrigerator repair in Aurora, CO
Aurora, CO Dispatch Hub
โ†’
refrigerator repair in Fort Collins, CO
Fort Collins, CO Dispatch Hub
โ†’
refrigerator repair in Lakewood, CO
Lakewood, CO Dispatch Hub
โ†’
refrigerator repair in Boulder, CO
Boulder, CO Dispatch Hub
โ†’
refrigerator repair in Albuquerque, NM
Albuquerque, NM Dispatch Hub
โ†’
refrigerator repair in Las Cruces, NM
Las Cruces, NM Dispatch Hub
โ†’
refrigerator repair in Rio Rancho, NM
Rio Rancho, NM Dispatch Hub
โ†’
Serving over 120+ cities across Colorado, Kansas, and New Mexico. View all municipal service areas โ†’
Dispatch: (945) 206-7476 Urgent Scenario: (855) 796-2411

Frequently Asked Questions: Bosch E02

What causes Bosch refrigerator error code E02?

The NTC thermistor sensor clipped to the freezer evaporator coil is reporting an open circuit, short circuit, or erratic reading outside normal range.

Can I reset the E02 code by unplugging the refrigerator?

While disconnecting power for 5 minutes may temporarily clear the display control memory, the E02 code will reoccur once the microcontroller detects the mechanical or electrical fault again.

What OEM replacement parts are required for Bosch E02?

Common OEM replacement components include: Freezer Evaporator NTC Thermistor Sensor (OEM #00623143), Main Electronic Power Control Board (OEM #11020478), Defrost Heater & Bimetal Thermostat Assembly (OEM #00649363).

How much does it cost to fix Bosch refrigerator error code E02?

Professional repair for Bosch refrigerator error code E02 typically averages $320 โ€“ $590 in total (including an estimated diagnostic fee of $89 โ€“ $149 plus labor and authentic OEM components). Sourcing authentic replacement parts yourself costs approximately $140 โ€“ $340. Final prices depend on model specifics, local labor rates, and physical technician inspection.

Dispatch: (945) 206-7476 Urgent: (855) 796-2411