Bosch Factory Service ManualFault Code: E29

Bosch Washer Error Code E29: Water Influx Pressure Unrecognized / Flow Low

The machine detected an unexpected drop in fill pressure or flow rate during mid-cycle wash or rinse fill operations.

OEM Brand: BoschAppliance: washerVerified OEM Diagnostics
Bosch washer diagnostic bench testing and technical inspection for error code E29
Bosch WASHER Diagnostic BenchCODE: E29
Target Appliance

washer

OEM Certified Technical Diagnostic Tree

Diagnostic Tool Required

Digital Multimeter

Measure Ohms resistance, continuity & line voltage.

Triage Complexity

Advanced Diagnostic

4 Sequential manufacturer inspection branches.

Sequential Factory Diagnostic Tree

Perform each diagnostic step in order. Disconnect electrical power and turn off utility shutoffs before inspecting wiring or internal mechanical assemblies.

Digital multimeter measuring ohms resistance and terminal pin continuity on appliance electronic control board
Bench Testing Protocol

Multimeter Resistance & Continuity Verification

Before replacing any electronic control board or mechanical sensor, disconnect power and measure terminal resistance using a calibrated digital multimeter. Verify continuity (0 ฮฉ) across safety switches and compare sensor resistance against OEM specs in the diagnostic steps below.

Step 1: Physical & Electrical InspectionMultimeter & Visual
Action: Inspect water supply shutoff valves behind washer and check supply hose strain relief.
Bench Test: Ensure cold water shutoff is fully opened and supply hose is not pinched against wall.
Expected Standard: Supply valve fully open; 20โ€“100 PSI dynamic flow.
If Failed / Out of Spec:

Open valve fully or replace damaged supply hose.

If Passed:

Proceed to Step 2.

Step 2: Physical & Electrical InspectionMultimeter & Visual
Action: Inspect mesh filter screens in the water inlet valve connection fittings.
Bench Test: Check screen mesh for silt, iron oxide particles, or hard water scale.
Expected Standard: Clean screen mesh with zero sediment occlusion.
If Failed / Out of Spec:

Extract and clean filter screens (00424981).

If Passed:

Proceed to Step 3.

Step 3: Physical & Electrical InspectionMultimeter & Visual
Action: Measure resistance across cold and rinse water valve solenoids.
Bench Test: Unplug solenoid terminals and test resistance using digital multimeter.
Expected Standard: 3.8k to 4.5k ohms across each solenoid coil.
If Failed / Out of Spec:

Replace water inlet triple valve assembly (00622324).

If Passed:

Proceed to Step 4.

Step 4: Physical & Electrical InspectionMultimeter & Visual
Action: Inspect electronic pressure sensor air bell on tub bottom.
Bench Test: Inspect plastic air dome for soapy sludge or detergent buildup dampening pressure pulses.
Expected Standard: Clean, clear air bell with unrestricted air passage.
If Failed / Out of Spec:

Flush air bell and replace pressure sensor hose (00605923).

If Passed:

Replace electronic pressure switch (00627460).

Verified OEM Replacement Parts

Cross-referenced factory part numbers for Bosch washer error code E29. Always replace defective components with authentic OEM parts to maintain UL safety certification.

Component NameOEM Part NumberManufacturerStatus
Water Inlet Solenoid Valve Assembly00622324BoschDirect Fit OEM
Electronic Water Level Pressure Switch00627460BoschDirect Fit OEM
Pressure Switch Air Tube Hose00605923BoschDirect Fit OEM

Estimated Repair Cost Ranges: Bosch E29

Repair costs for Bosch washers displaying error code E29 vary based on component damage, accessibility, and whether you self-install or dispatch a local factory-trained technician.

DIY Replacement Part

$45 โ€“ $145

Direct OEM replacement part cost (excluding tools, shipping, or diagnostic meter equipment).

Pro Diagnostic Fee

$89 โ€“ $149

Standard in-home diagnostic evaluation fee by an independent technician (typically applied toward repair).

Total Pro Repair Range

$220 โ€“ $440

Typical total job cost including in-home diagnostic, authentic OEM parts, and professional labor (45โ€“75 mins).

Pricing & Diagnostic Disclosure:

The pricing figures provided above represent broad industry averages based on nationwide market surveys and component replacement requirements. Pricing depends on multiple factors including the specific appliance brand, age, mechanical condition, diagnostic complexity, accessibility, and local labor rates. All independent repair contractors set their own independent rates and fee structures. An in-home diagnostic evaluation by an authorized technician is required to provide an exact written quote prior to any repair work.

Related Symptom Triage Guides for Bosch washers

If your appliance displays code E29 alongside physical operational symptoms, consult our dedicated failure triage flowcharts:

Symptom Triage

Why Are Clothes Still Soaking Wet After the Washer Spin Cycle?

View Triage Flowchart โ†’
Symptom Triage

Why Does My Washing Machine Smell Like Mildew or Rotten Eggs?

View Triage Flowchart โ†’
Symptom Triage

Why Is My Front Load Washer Door Locked and Won't Open? Diagnostics

View Triage Flowchart โ†’
Symptom Triage

Why Is My Washing Machine Leaking Water? Diagnostic Guide

View Triage Flowchart โ†’
Engineering Service Hub

Looking for Full Washing Machine Repair Procedures?

Explore comprehensive diagnostic mechanics, component resistance curves, and EPA guidelines for Bosch units.

Washing Machine Repair Specs โ†’
Local In-Home Diagnostic Dispatch

Tired of Troubleshooting Code E29? Get a Local Bosch Technician.

If multimeter bench tests confirm component failure or you prefer a professional to safely service your high-voltage Bosch washer, connect with an independent certified specialist in Colorado, Kansas, or New Mexico today.

(945) 206-7476 Urgent: (855) 796-2411Mon-Sun 7amโ€“9pm โ€ข Fast Local Dispatch
Local In-Home Service DispatchSame-Day Available

Need In-Home Diagnostic Dispatch for Code E29?

If multimeter testing confirms an internal short, failed heating element, locked motor, or burnt control board on your Bosch washer, connect with an independent certified technician in your city.

washing machine repair in Olathe, KS
Olathe, KS Dispatch Hub
โ†’
washing machine repair in Overland Park, KS
Overland Park, KS Dispatch Hub
โ†’
washing machine repair in Wichita, KS
Wichita, KS Dispatch Hub
โ†’
washing machine repair in Lawrence, KS
Lawrence, KS Dispatch Hub
โ†’
washing machine repair in Topeka, KS
Topeka, KS Dispatch Hub
โ†’
washing machine repair in Kansas City, KS
Kansas City, KS Dispatch Hub
โ†’
washing machine repair in Denver, CO
Denver, CO Dispatch Hub
โ†’
washing machine repair in Colorado Springs, CO
Colorado Springs, CO Dispatch Hub
โ†’
washing machine repair in Aurora, CO
Aurora, CO Dispatch Hub
โ†’
washing machine repair in Fort Collins, CO
Fort Collins, CO Dispatch Hub
โ†’
washing machine repair in Lakewood, CO
Lakewood, CO Dispatch Hub
โ†’
washing machine repair in Boulder, CO
Boulder, CO Dispatch Hub
โ†’
washing machine repair in Albuquerque, NM
Albuquerque, NM Dispatch Hub
โ†’
washing machine repair in Las Cruces, NM
Las Cruces, NM Dispatch Hub
โ†’
washing machine repair in Rio Rancho, NM
Rio Rancho, NM Dispatch Hub
โ†’
Serving over 120+ cities across Colorado, Kansas, and New Mexico. View all municipal service areas โ†’
Dispatch: (945) 206-7476 Urgent Scenario: (855) 796-2411

Frequently Asked Questions: Bosch E29

What causes Bosch washer error code E29?

The machine detected an unexpected drop in fill pressure or flow rate during mid-cycle wash or rinse fill operations.

Can I reset the E29 code by unplugging the washer?

While disconnecting power for 5 minutes may temporarily clear the display control memory, the E29 code will reoccur once the microcontroller detects the mechanical or electrical fault again.

What OEM replacement parts are required for Bosch E29?

Common OEM replacement components include: Water Inlet Solenoid Valve Assembly (OEM #00622324), Electronic Water Level Pressure Switch (OEM #00627460), Pressure Switch Air Tube Hose (OEM #00605923).

How much does it cost to fix Bosch washer error code E29?

Professional repair for Bosch washer error code E29 typically averages $220 โ€“ $440 in total (including an estimated diagnostic fee of $89 โ€“ $149 plus labor and authentic OEM components). Sourcing authentic replacement parts yourself costs approximately $45 โ€“ $145. Final prices depend on model specifics, local labor rates, and physical technician inspection.

Dispatch: (945) 206-7476 Urgent: (855) 796-2411